Page Loading…
CMS - The Complete Solutions Provider
Cable Management - Cabinets - Assynia - Hellermann Tyton
Layout Table~~~~106425~106425~~
Banner~~~~106425~106433~~
New Layout Table~~~~106425~106463~~
Page Breadcrumb~~~~106425~106432~~
New Layout Table~~~~106425~106431~~
Dat-Mat Cable Protection~
Recent industry reports reveal that, due to flooding, 30% of structured cabling is replaced before the building ishanded over to the client. Both DAT-MAT and DAT-DUCT are designed to minimise this risk and the inevitableinsurance claims, which can arise.
~~~106425~106430~~
Dat-Mat Cable Protection
|
New Layout Table~~~~106425~106429~~
Product Header~
Code
Width
Thickness
Length
~~~106425~106428~~
300mm DAT-MAT Cable Protector~
DM300-5P
300mm
5mm
2 m
~
BACKGROUND
Recent industry reports reveal that, due to flooding, 30% of structured cabling is replaced before the building is handed over to the client. Both DAT-MAT and DAT-DUCT are designed to minimise this risk and the inevitable insurance claims, which can arise.
Water ingress into the data cabling system can have a serious effect on the cable’s ability to support high bit rate data, ie: Gigabit Ethernet. When the cable gets wet the dielectric performance is changed, affecting impedanceand the related parameters of attenuation and return loss.
It is a common misunderstanding that PVC data cables are waterproof; they are not, the are hygroscopic. Standard Cat5e and Cat6 cables have a pvc coating which is designed for indoor use. It is not suitable in wet conditions.
PRODUCT INFORMATION
Mita’s DAT-MAT is a low smoke zero halogen (LS0H) water resistant polymer mat, designed for laying cables under raised floors. By raising Data Cables off of the floor, DAT-MAT protects against low water flooding, attack fromchemicals in the floor screed, and also sharp edges in the floor finish.
Supplied in 2m lengths
Lightweight
Easy to cut on site
No earthing required - therefore saving time on installation and low maintenance
LS0H and water resistant material makes DAT-MAT ideal for under floor applications, by raising cables off the floor
this will protect against low flooding
Standard thickness 5mm
Standard width 300mm and 550mm. Other widths available
Direct laying of data cables onto the concrete floor can result in potential chemical contamination, DAT-MAT will form
a barrier between the two components
If required, DAT-MAT can be installed into a wire basket
TECHNICAL DATA
According to 91/155/EEC
Introduction:
Polyflute is extruded from polypropylene co-polymer granulesPhysical Characteristic:Physical Appearance: SheetColour: PurpleMelting Point: >160oC
Stability and Reactivity:
The product is stable at normal handling and storage conditions and no polymerisation may occur
Toxicity:
The material is chemically unreactive and biologically inert.The material has been widely used in the food industry since 1967 and has full FDA approval
Ecological Information:
Extremely low water solubility. Low volatility. No environmental hazards known
Hazard Classification:
Not classified as dangerous according to Directive 1999/45/EC
Tranportation:
Not classified as hazardous under European transport regulations
Inflammability:
Low smoke and fumes
Minimum self ignition temperature ca 375oC (ASTM D 1929)
Minimum flash-ignition temperature ca 310oC (ASTM D 1929)
UL flame class 94HB. Oxygen Index 17.4% - 18% (ASTM D 635)
Softening temperature ca 144oC
Crystaline melting point ca 160oC
Tested to:
BS476: Part 12 (1991) Flame Test
Pr EN 2824 Toxicity
BS2782: Par 1: 141: 1986 Oxygen Index
Click on the link below to go to the page where the full listing of CableLay can be found.
~300mm DAT-MAT Cable Protector|DM300-5P|~106425~106427~DAT-MAT, Cable Protector, DM300-5P~
550mm DAT-MAT Cable Protector~
DM550-5P
550mm
5mm
2 m
~
BACKGROUND
Recent industry reports reveal that, due to flooding, 30% of structured cabling is replaced before the building is handed over to the client. Both DAT-MAT and DAT-DUCT are designed to minimise this risk and the inevitable insurance claims, which can arise.
Water ingress into the data cabling system can have a serious effect on the cable’s ability to support high bit rate data, ie: Gigabit Ethernet. When the cable gets wet the dielectric performance is changed, affecting impedanceand the related parameters of attenuation and return loss.
It is a common misunderstanding that PVC data cables are waterproof; they are not, the are hygroscopic. Standard Cat5e and Cat6 cables have a pvc coating which is designed for indoor use. It is not suitable in wet conditions.
PRODUCT INFORMATION
Mita’s DAT-MAT is a low smoke zero halogen (LS0H) water resistant polymer mat, designed for laying cables under raised floors. By raising Data Cables off of the floor, DAT-MAT protects against low water flooding, attack fromchemicals in the floor screed, and also sharp edges in the floor finish.
Supplied in 2m lengths
Lightweight
Easy to cut on site
No earthing required - therefore saving time on installation and low maintenance
LS0H and water resistant material makes DAT-MAT ideal for under floor applications, by raising cables off the floor
this will protect against low flooding
Standard thickness 5mm
Standard width 300mm and 550mm. Other widths available
Direct laying of data cables onto the concrete floor can result in potential chemical contamination, DAT-MAT will form
a barrier between the two components
If required, DAT-MAT can be installed into a wire basket
TECHNICAL DATA
According to 91/155/EEC
Introduction:
Polyflute is extruded from polypropylene co-polymer granulesPhysical Characteristic:Physical Appearance: SheetColour: PurpleMelting Point: >160oC
Stability and Reactivity:
The product is stable at normal handling and storage conditions and no polymerisation may occur
Toxicity:
The material is chemically unreactive and biologically inert.The material has been widely used in the food industry since 1967 and has full FDA approval
Ecological Information:
Extremely low water solubility. Low volatility. No environmental hazards known
Hazard Classification:
Not classified as dangerous according to Directive 1999/45/EC
Tranportation:
Not classified as hazardous under European transport regulations
Inflammability:
Low smoke and fumes
Minimum self ignition temperature ca 375oC (ASTM D 1929)
Minimum flash-ignition temperature ca 310oC (ASTM D 1929)
UL flame class 94HB. Oxygen Index 17.4% - 18% (ASTM D 635)
Softening temperature ca 144oC
Crystaline melting point ca 160oC
Tested to:
BS476: Part 12 (1991) Flame Test
Pr EN 2824 Toxicity
BS2782: Par 1: 141: 1986 Oxygen Index
Click on the link below to go to the page where the full listing of CableLay can be found.
~550mm DAT-MAT Cable Protector|DM550-5P|~106425~106434~DAT-MAT, Cable Protector, DM550-5P~
Black Product Divider~~~~106425~106426~~
Menu Page
|
Toolbar Page
|
Frameset Page
|
Index Page
|
Table of Contents
EROL - Electronic Retail Online E-commerce shopping cart software